Twenty years ago, the fuel gauge IC did not appear. The earliest design was that the single chip microcomputer detected the battery voltage through the AD port to determine the remaining battery capacity. This method of voltage detection discharges the battery small current, and the battery power error is still accurate because If the voltage gradually decreases, just set a few fixed voltage points to judge, such as 100%, 75%, 50%, 25%, 10% voltage corresponding to several capacities...
After years of development, the lithium battery industry has formed a complete industrial chain with a high degree of specialization. Do you know how the lithium battery is made?
BYD: The blade battery can still discharge 90% at minus 10°C, with a mileage of 1.2 million kilometers
The battey as one of the most important parts of electric vehicles, batteries are also valued by major car companies. At present, there are mainly two types of batteries used by car companies to install vehicles: ternary lithium batteries and lithium iron phosphate batteries. However, BYD's blade battery (a new generation of lithium iron phosphate battery) was born, and car companies also have a more competitive battery option.
The INRUSH PEAK discharge current and continuous discharge current mainly depend on the battery cell. The overcurrent protection of the protection board only sets a safe discharge current parameter for the battery. If the battery works within this safety parameter, no safety will occur. (but if the discharge current exceeds the load current of the cell allowed, it may also shorten the battery cycle life)
Both the camera drone battery and the mobile phone battery are lithium-ion batteries. The drone battery is the source of power for the device and has higher requirements for its safety performance. However, there is a difference between the two. The drone battery has a significant feature compared to the mobile phone battery --- high rate discharge. The drone battery needs a large current to discharge to meet the requirements of the drone in different environments. For example, in aerial photography, if a strong wind is encountered, the battery must be discharged with a large current to ensure the stability of the drone's position. Because of different requirements, the life of the camera drone battery is relatively short.
Polymer lithium ion battery is a kind of lithium ion battery, but compared with liquid lithium ion battery (Li-ion), it has high energy density, more compact, ultra-thin, light weight, high safety and low cost Many obvious advantages are a new type of battery. Below we detail the advantages and disadvantages of polymer lithium-ion batteries:
Generally speaking, the most common power batteries are lithium iron phosphate batteries, lithium manganate batteries, lithium cobalt oxide batteries, and ternary lithium batteries.
Different types of batteries have different internal resistances. For the same type of battery, due to the inconsistent internal chemical characteristics, the internal resistance is also different. The internal resistance of the battery is very small, we generally use milliohm units to mean it. Internal resistance is an important technical indicator to measure battery performance. Under normal circumstances, a battery with a small internal resistance has a strong high-current discharge capability, and a battery with a large internal resistance has a weak discharge capability. In terms of the schematic diagram of the discharge circuit, we can dissect the battery and the internal resistance and divide it into a power supply with no internal resistance connected in series with a small resistance......
The overwhelming majority of 18650 lithium batteries are encapsulated in steel shells. Due to the lack of protection, over-charged batteries will suddenly increase their internal pressure and explode when they exceed the withstand value. Short circuit, excessive temperature or squeezing or even puncturing the battery may cause the battery to explode.
Parallel connection: Several batteries, the positive electrode and the positive electrode, the negative electrode and the negative electrode are connected together side by side, the voltage remains unchanged, the capacity increases, and the corresponding current also increases.
Serial connection: Several batteries are connected in series, that is, the positive electrode and the negative electrode. The negative electrode of the first battery is connected to the positive electrode of the second battery, and so on. The voltage increases, the capacity does not change.